Typically a flat roof is a low sloping roof with a maximum 10 degrees of pitch or usually having a slope of up to 3 inches per linear foot for adequate drainage.
Liberty peel and stick roofing installation.
Do install on roofs between 1 2 and 6 per foot incline and backnail the liberty cap sheet when the slope is greater than.
Liberty sbs self adhering roofing system will provide long lasting protection for the low slope areas of your property without the danger or hassles associated with the installation of other conventional roofing products.
Gaf peel and stick roofing.
Gaf would not recommend installing the liberty cap sheet over a shingle roof.
Peel and stick roofing.
Learn about the liberty sbs self adhering base ply sheet.
Installing peel and stick roll roofing on a flat roof requires a minimum slope of 1 2 inch per 12 inch roof run.
Gaf mastering the roof chapter 14 the liberty system is designed for both new roofing and re roofing applications.
Liberty systems are applied without torches open flames hot asphalt or solvent based adhesives and are suitable for many primed substrates.
This segment covers the installation of liberty cap sheet liberty base sheet and liberty self adhering base ply sheet.
Videos are intended for u s users only unless otherwise noted.
A self adhering roofing system will provide long lasting protection for the low slope areas of your property without the danger or hassles associated with the installation of other conventional roofing products.
Gaf liberty base sheet see all.
It can be installed over a primed plywood deck or approved insulation or coverboards.
Welcome welcome 4 welcome thank you for consulting version 1 0 of the liberty sbs self adhered roofing systems manual.
It can be installed over a primed plywood deck or approved insulation or coverboards.
Gaf would not recommend installing the liberty cap sheet over a shingle roof.
Liberty roofing systems are applied without torches open flames hot asphalt or messy solvent based adhesives.
Liberty sbs self adhering roofing systems are designed to be installed over low sloped roof decks.